Choose a Layer on which to place the routed elements. Adjust additional Routing Options as needed. Choose an MEP System attribute for this Routing operation.ħ. In this image, the reference line during routing runs along the top left corner of the duct, as viewed in the direction of routing.Ħ. You can switch this location en route as needed.) (This reference line is relevant only during a Routing operation, and indicates the anchor point of the routed elements when you click on screen to place them. Reference Line location/Elevation: Choose one of the nine points in the Routing palette to define the location of the reference line of the routed elements, at the given elevation. To show the selection tool in the toolbar. To remove items to the toolbar, select View > Toolbars, and select an item with a check mark. To add items to the toolbar, select View > Toolbars, and select an item without a check mark. Once you start routing, you can switch to another routing elevation as you proceed. You can add items to or remove items from the toolbar, and you can customize the appearance of toolbar items. All new routes are set to “ Constant Elevation” (the horizontal arrow). The Construction Method is not editable until after you start Routing. ( Options > Project Preferences > MEP Preferences).Ĥ. – The list of predefined Duct and Pipe sizes can be edited in MEP Preferences. – Enter a predefined height or width from the pop-up, or choose Custom to type in any custom value. Enter a diameter or height/width values for the cross-section, as applicable. Choose a cross-section geometry preference for the routed elements: Rectangular, Circular, Oval or (Ductwork only) Flexible.ģ. Choose either Ductwork, Pipework or Cabling from the top dropdown menu.Ģ. Option 1: if you have a blank plate down, press the Layer toggle. These options can be changed in the midst of a routing operation.ġ. If you find yourself in the situation where this is missing this can be easily switched back on in one of two ways. Set the desired options on the MEP Routing palette ( Window > Palettes > MEP Routing).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |